Sansonic HNB-B Installationsanleitung PDF herunterladen (Seite 30)

SonicDevices n 9950 Baldwin Place, El Monte CA 91731 n (T) 626-454-8169 n (F) 626-433-1079 n (W) www.sonicdevices.net

Installation and Technical Application Guide

igital multimedia mixer for Audio, Video and Wireless applications

Page 30

SECTION 7.0 - HNB-C Wireless Microphone Pairing, Channel Activation, and Charging

7.1 Wireless Microphones: Pairing and Power Overview

7.2 TM2 and TM3 Teacher Microphone - Channel 1 Activation (TM1 is outlined in a separate document)

NOTE:

Microphone pairing and pow-

ering is done after HNB-A is

terminated to HNB-C. Please

follow the steps outlined in 7.2

- 7.5 to activate the teacher

and student microphones.

Each HB-Rx Receiver mod-

ule has two (2) channels

perating at independent fre-

quencies (2.4GHz / 900MHz).

Channel 1 is for the Teacher

Microphone (model TM2 or

TM3).

Channel 2 is for the Student

Microphone (model SM1).

Step 1: Press the power (PWR) button on the

HB-Rx receiver module for Channel 1.

Power ON = Blue LED flashing.

Step 2: Press the ON/ OFF button on the

transmitter for the teacher microphone

(TM2 or TM3).

ON = Blue LED flashing or Blue LED

steady.

Tip: if the LED's on both units (HB-Rx and

transmitter) continue flashing then proceed

to Step 3 'Pairing'. If the LED's are solid

(ON, but not flashing) then the units linked

themselves and are ready to broadcast. Go

to Step 5 'Volume'.

LED Blue / Red

ON / OFF

Transmitter

for teacher microphone (TM2 or TM3)

NOTES:

HNB-C microphones are

factory 'paired' and should

connect when power is

pressed ON showing a

STEADY blue LED

condition.

ALL HNB Microphones can

be 'paired' to ANY HNB-C

unit in under ten (10)

seconds.

HNB-C microphones should

be fully charged to insure

proper operation.

LED-IR lens

Blue / Red

HB-Rx Receiver Module

(close-up of Channel 1 - Teacher Microphone)

TM2 TM3

Teacher Mic Teacher Mic

w transmitter w transmitter

Channel 1: TM2 or TM3 Microphone

Receiver

Channel 2: SM1 Microphone

HNB-C

Important Note: Cell phones must be 1M(3’) away from microphone.

Sansonic HNB A+B+C installmaULb:Sansonic HNB A+B+C installmaULb 6/29/11 6:40 PM Page 30

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

Kommentare zu diesen Handbüchern

Keine Kommentare

Sansonic HNB-B Installationsanleitung Seite 30

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Audioverstärker Sansonic HNB-B