Sansonic HNB-B Installationsanleitung PDF herunterladen (Seite 35)

SonicDevices n 9950 Baldwin Place, El Monte CA 91731 n (T) 626-454-8169 n (F) 626-433-1079 n (W) www.sonicdevices.net

Page 35

Installation and Technical Application Guide

igital multimedia mixer for Audio, Video and Wireless applications

7.9 Microphone Charging

Please read the following terms and conditions, as they are affected by

the installation conditions as well as SonicDevices obligations and condi-

tions which must be met to activate them. SonicDevices does not

assume nor does it authorize any person to assume or extend on its

behalf any other warranty obligation or liability.

SonicDevices Digital Audio Mixer Amplifier Model HNB-A, HNB-B,

HNB-C and all related accessories are warranted for a period of

three (3) years from the date of shipment to the customer. During

such warranty period the electronic unit shall be free from defects in

materials or factory workmanship so that the electronic unit shall substan-

tially conform to the SonicDevices published specifications. The warran-

ty applies to all first quality products. This limited warranty is subject to

further conditions as outlined below.

All electronic units shall be installed and used in accordance with

SonicDevices specifications in effect at the time of installation.

SonicDevices will not be responsible for defects caused by improper or

unreasonable use, water intrusions, lightning, or malfunctions when elec-

tronic units have been modified or operated in excess of their rated

capacities, altered, serviced, or installed in an other than workman-like

manner or industry accepted practices.

This limited warranty is void if the label bearing the electronic units date of

manufacture and serial number is removed or otherwise defaced to the

point of not being legible.

You must notify SonicDevices of any electronic unit failure covered by

this warranty within (30) days of first observation of failure by writing (elec-

tronic or paper) to the Customer Service department at: SonicDevices,

9950 E. Baldwin Place, El Monte, CA 91731 (T) 626-454-8203,

(F) 626-466-1338 www.sonicdevices.net.

After an inspection has been conducted by SonicDevices or its

authorized Representatives, and the validity of the return has been

verified, a written Return Authorization (RA) to return must be issued by

SonicDevices prior to any return. Electronic devices returned and found

to be defective, in SonicDevices sole judgment, will either be replaced

(replacement products may be remanufactured or reconditioned devices)

or repaired without charge. The replaced or repaired electronic unit is

warranted for the remainder of the original warranty period.

The foregoing constitutes the entire obligation of SonicDevices, and

there are not other warranties expressed or implied, including any warran-

ty or merchantability or fitness for any purpose whatsoever. Liability is

limited to the above, and SonicDevices, shall in no event be liable for

any incidental or consequential damages other than to replace or repair

the electronic device(s) itself.

Please note: Some jurisdictions do not allow exclusion or limitation of inci-

dental or consequential damages or limitations on how long an implied

warranty lasts, so the above limitation or exclusion may not apply to you.

Reference to SonicDevices in this section shall mean, for the United

States: SonicDevices, 9950 Baldwin Place, El Monte, CA 91731.

SECTION 8.0 - HNB-A + HNB-B + HNB-C WARRANTY

M1 TM2 TM3 SM1

Teacher Mic Teacher Mic Teacher Mic Student Mic

built-in transmitter w transmitter w transmitter w charging stand

attery charger w

6v Power supply

All HNB microphones: TM1, TM2, TM3 and SM1 use a battery

charger with 6V wall power supply included. The power supply is UL

/ Energy Star rated and plugs into a standard 120VAC outlet.

All HNB microphones and receivers have a FAST charging time;

50% recharge in (30) minutes, 100% FULL recharge in (90)

minutes (nominal). During charging front LED for TM1, TM2,

TM3 and HB-RU receiver will begin as Bright Green and when

fully charged will 'dim'. This is normal. The units will operate for

5-6 hours of continuous talk time when fully charged.

SM1 Charging Stand Assembly

Student hand-held microphone battery charger

requires assembly of metal holder into the charging

base. Simply insert the metal holder and into the

base allowing the microphone to be placed into the

holder and supported vertically inside the base.

The 6V wall charger power supply terminates to

the USB mini jack on the base. When fully charged

in (90) minutes the SM1 will operate for 6-8 hours

of continuous talk time. Charging stand has LED

charging status colors of:

Blue=ON, Red=Charging, Green=Fully Charged.

SM1 Charging stand

Metal holder

Sansonic HNB A+B+C installmaULb:Sansonic HNB A+B+C installmaULb 6/29/11 6:40 PM Page 35

1 2 ... 30 31 32 33 34 35 36

Kommentare zu diesen Handbüchern

Keine Kommentare

Sansonic HNB-B Installationsanleitung Seite 35

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Audioverstärker Sansonic HNB-B